1. eNTUKhPIIR

Browsing by Author Kundrak, Janos

Jump to: 0-9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
А Б В Г Д Е Є Ж З И І Ї Й К Л М Н О П Р С Т У Ф Х Ц Ч Ш Щ Ъ Ы Ь Э Ю Я

or enter first few letters:  
Showing results 1 to 19 of 19
Issue DateTitleAuthor(s)
2021Analysis of the change in roughness on a face-milled surface measured every 45° direction to the feedNagy, Antal; Kundrak, Janos
2019Comparative analysis of CBN cutting inserts with different edge geometriesKundrak, Janos; Sztankovics, Istvan; Gevai, Martina
2011Comparison of finish machining procedures on the basis of material removal performanceKundrak, Janos; Deszpoth, I.
2011Comparison of hard machining procedures on the basis of the amount of the used up coolant and lubricantKundrak, Janos
2022Decision support method for the applicability of hard turningKundrak, Janos; Deszpoth, Istvan; Molnar, Viktor
2011The effect of tool wear on chip formation in hard turningSzabo, G.; Kundrak, Janos
2019Face milling with a round insert at various cutting speeds and feed ratesMakkai, Tamas; Kundrak, Janos; Karkalos, Nikolaos E.; Markopoulos, Angelos P.
2010Finite element modelling of shear in hard turningKundrak, Janos; Szabo, G.; Varga, Gy.
2019Increasing productivity of combined procedure by reducing grinding allowanceKundrak, Janos; Deszpoth, Istvan; Molnar, Viktor
2019Influence of depth of cut and cutting speed on cutting forces in face milling under constant chip cross-section conditionsKarkalos, Nikolaos E.; Markopoulos, Angelos P.; Makkai, Tamas; Kundrak, Janos
2016Influences of the technological parameters on the surface twist in grindingNagy, Nora; Kundrak, Janos
2019Investigation of surface roughness characteristics of face millingNagy, Antal; Kundrak, Janos
2019Investigation of surface roughness on face milled parts with round insert in planes parallel to the feed at various cutting speedsKundrak, Janos; Nagy, Antal; Markopoulos, Angelos P.; Karkalos, Nikolaos E.
2019Investigation of the effect of depth of cut and cutting speed on cutting forces during face milling of steel with a rectangular cutting insertKarkalos, Nikolaos E.; Markopoulos, Angelos P.; Makkai, Tamas; Kundrak, Janos
2011Investigation on wear and tool life of cutting toolsKundrak, Janos; Raczkovi, L.
2019Joint machining: hard turning and grindingKundrak, Janos; Molnar, Viktor; Markopoulos, Angelos P.
2019Lead time reduction in manufacturing process of toothed partsMolnar, Viktor; Deszpoth, Istvan; Kundrak, Janos
2011Research of plastic strain and chip morphology in hard turningKundrak, Janos; Szabo, G.
2022Theoretical value and experimental study of arithmetic mean deviation in rotational turningSztankovics, István; Kundrak, Janos
Showing results 1 to 19 of 19