1. eNTUKhPIIR

Browsing by Author Markopoulos, Angelos P.

Jump to: 0-9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
А Б В Г Д Е Є Ж З И І Ї Й К Л М Н О П Р С Т У Ф Х Ц Ч Ш Щ Ъ Ы Ь Э Ю Я

or enter first few letters:  
Showing results 1 to 14 of 14
Issue DateTitleAuthor(s)
2020Efficiency of material removal and machining in cuttingMolnár, Viktor; Deszpoth, István; Kundrák, János; Markopoulos, Angelos P.
2021Experimental investigation of surface topography of AL7075-T6 alloy machined by EDMBalanou, M.; Papazoglou, E. l.; Markopoulos, Angelos P.; Karmiris-Obratański, P.
2020Experimental study on surface roughness of face milled parts with round insert at various feed ratesKundrák, János; Nagy, Antal; Markopoulos, Angelos P.; Karkalos, Nikolaos E.; Skondras-Giousios, D.
2019Face milling with a round insert at various cutting speeds and feed ratesMakkai, Tamas; Kundrak, Janos; Karkalos, Nikolaos E.; Markopoulos, Angelos P.
2019Influence of depth of cut and cutting speed on cutting forces in face milling under constant chip cross-section conditionsKarkalos, Nikolaos E.; Markopoulos, Angelos P.; Makkai, Tamas; Kundrak, Janos
2017Investigating the impact of feed and cutting speed on cutting forces for the increase of surface removal rate in face millingKundrák, János; Makkai, Tamás; Markopoulos, Angelos P.
2019Investigation of surface roughness on face milled parts with round insert in planes parallel to the feed at various cutting speedsKundrak, Janos; Nagy, Antal; Markopoulos, Angelos P.; Karkalos, Nikolaos E.
2019Investigation of the effect of depth of cut and cutting speed on cutting forces during face milling of steel with a rectangular cutting insertKarkalos, Nikolaos E.; Markopoulos, Angelos P.; Makkai, Tamas; Kundrak, Janos
2019Joint machining: hard turning and grindingKundrak, Janos; Molnar, Viktor; Markopoulos, Angelos P.
2019Knee implant study and evaluation with axiomatic design methodMarkopoulos, Angelos P.; Souleles, Konstantinos P.
2020On the machining of aluminum alloy AL6063 with EDMPapazoglou, E. L.; Karkalos, Nikolaos E.; Markopoulos, Angelos P.; Karmiris-Obratański, P.
2022On the surface roughness of 3D printed parts with FDM by a low-budget commercial printerChristodoulou, I. T.; Alexopoulou, V. E.; Karkalos, Nikolaos E.; Papazoglou, E. L.; Markopoulos, Angelos P.
2019Study on mesh dependence of cutting zone dimensions prediction during abrasive waterjet machiningDimopoulos, Christos D.; Karkalos, Nikolaos E.; Markopoulos, Angelos P.
2019Study on the applicability of coupled Eulerian-Lagrangian formulation in abrasive waterjet machining simulationsDimopoulos, Christos D.; Karkalos, Nikolaos E.; Markopoulos, Angelos P.
Showing results 1 to 14 of 14