Finite element modelling of shear in hard turning

Loading...
Thumbnail Image

Date

item.page.orcid

item.page.doi

item.page.thesis.degree.name

item.page.thesis.degree.level

item.page.thesis.degree.discipline

item.page.thesis.degree.department

item.page.thesis.degree.grantor

item.page.thesis.degree.advisor

item.page.thesis.degree.committeeMember

Journal Title

Journal ISSN

Volume Title

Publisher

НТУ "ХПИ"

Abstract

The major problem of a choice of optimum finishing operation is solved at processing internal surfaces tempered of steels. Parameters by means of which it is obviously possible to carry out a choice of optimum operation turning or grindings are offered. The comparative analysis of efficiency of application of these operations has shown, that turning operation internal apertures at which the attitude of length to diameter does not exceed 1,1 is preferable.
The major problem of a choice of optimum finishing operation is solved at processing internal surfaces tempered of steels. Parameters by means of which it is obviously possible to carry out a choice of optimum operation turning or grindings are offered. The comparative analysis of efficiency of application of these operations has shown, that turning operation internal apertures at which the attitude of length to diameter does not exceed 1,1 is preferable.

Description

Citation

Kundrak J. Finite element modelling of shear in hard turning / J. Kundrak, G. Szabo, Gy. Varga // Сучасні технології в машинобудуванні = Modern technologies in mechanical engineering : зб. наук. пр. – Харків : НТУ "ХПІ", 2010. – Вип. 4. – С. 211-216.

Endorsement

Review

Supplemented By

Referenced By