Перегляд за Автор "Anishchenko, G. O."
Зараз показуємо 1 - 5 з 5
Результатів на сторінці
Налаштування сортування
Документ Analysis of Various Approaches to Modeling of Dynamics of Lifting-Transport Vehicles(Science Publishing Corporation, 2018) Grigorov, O. V.; Druzhynin, E. I.; Anishchenko, G. O.; Strizhak, M. G.; Strizhak, V. V.The results of analytical and numerical modeling of dynamic characteristics of linear and non-linear mathematical models of the "trolleyload" system of bridge and container cranes are presented. KiDyM software complex is used for numerical modeling, which, based on the use of the apparatus of structural matrices and the built-in computer algebra system, allows the construction of ordinary differential equations of motion of the class of systems under consideration at the analytical level. Recommendations on the possible use of the considered mathematical models of the "trolley-load" system in various regular and forced operation modes of bridge and container cranes are given on the basis of the analysis. The ratio of the results of calculations for various design models of regular and forced operation of the bridge crane has been established. The magnitude of the distribution of the maximum values of the dynamic characteristics of motion of the container crane has been designed by calculating the forced operation mode using various mathematical models.Документ Comparing hydraulic and electromechanical drives by electric motor's power(2019) Grigorov, O. V.; Anishchenko, G. O.; Druzhynin, E. I.; Strizhak, V. V.; Strizhak, M. G.; Mаlashchenkо, V. O.The authors have made the analysis of energy consumption by positive-displacement hydraulic drive and asynchronous motor with phase rotor in the course of crane mechanisms operation at all stages of motion: acceleration, movement at nominal or intermediate speed, and deceleration. There have been determined and compared equivalent capacities per work cycle for electric and hydraulic drives of crane mechanisms depending on operating conditions group and operation time. There has been justified the decrease of rated capacity of electric motor of crane mechanisms’ hydraulic drive as compared with the case of applying asynchronous motor with phased rotor for the same mechanisms.Документ Numerical simulation of the dynamics of the system "trolley – load – carrying rope" in a cable crane(РC Tесhnology сеntеr, 2018) Grigorov, O. V.; Druzhynin, E. I.; Strizhak, V. V.; Strizhak, M. G.; Anishchenko, G. O.We report results of research into patterns in the progress of dynamic processes and into emergence of dynamic loads when a trolley of the cable crane moves with a suspended load. These patterns could be subsequently taken into consideration when calculating actual cranes, in order to improve their reliability and durability, to avoid unfavorable events during motion of a freight trolley, as well as to define parameters of cranes of the new design. The dynamics of a cable crane is considered from the point of view of the interaction between elements of the system "trolley-load-carrying rope". We have improved a mathematical model for the system "trolley-load-carrying rope" by introducing three damping coefficients, each of which characterizes energy dissipation under different physical processes ‒ the motion of a trolley, a load, and the speed of a wind load. Numerical simulation was performed using the software package KiDyM, which at the analytical level allows the construction of motion equations for the systems that are described by a combination of ordinary differential equations. We established patterns of change in the normal and tangential inertial forces occurring during motion of the trolley along a curvilinear trajectory. Their character and magnitude were quantified. We determined dynamic characteristics of the system, taking into consideration the influence of the masses of a swinging load, a trolley, and the curvature of a rope. Emergency mode that occurs at a break of the traction rope was investigated, as well as the influence of wind load on the swinging of the load. We defined causes for the emergence of the reverse speed for a freight trolley, and the ways for its elimination. The influence of wind load on the angle of load deviation from the vertical was examined.Документ Testing of hydrodynamic drive of cranes mechanisms(AGIR Publishing House, Bucharest, Romania, 2020) Grigorov, O. V.; Anishchenko, G. O.; Petrenko, N.; Strizhak, V. V.; Turchyn, O. V.; Strizhak, M. G.; Okun, A. O.; Radchenko, V.The results of researches on the cranes (bridge, tower and portal) with hydrodynamic drives of travel and slewing mechanisms are given. Recommendations for a significant increase hydraulic drives elements limit number of fatigue cycles in relation to a drive with a phase rotor are given.Документ Testing of hydrostatic drive of cranes mechanisms(AGIR Publishing House, Bucharest, Romania, 2019) Grigorov, O. V.; Anishchenko, G. O.; Petrenko, N.; Strizhak, V. V.; Turchyn, O. V.; Strizhak, M. G.; Okun, A. O.At present, the experts of lifting, transport, construction and road equipment are tasked with significantly improving the productivity of loading and unloading operations, improving performance characteristics, increasing the durability and reliability of machines. One of the ways of solving these problems is the widespread use of hydraulic transmissions in various mechanisms of cranes, construction and road machines. The results of researches on the cranes (bridge, tower and portal) with hydrostatic drives of travel and slewing mechanisms are given. The results of testing are compared with the solutions on the computer. Recommendations for a significant increase hydrostatic drives limit number of fatigue cycles of welded joints of crane steel structures in relation to a drive with a phase rotor are given.