Довгополов, Андрій ЮрійовичНекрасов, Сергій Сергійович2017-01-302017-01-302016Довгополов А. Ю. Технологія обробки гвинтової поверхні роз'ємного з'єднання в деталях з армованих композиційних матеріалів / А. Ю. Довгополов, С. С. Некрасов // Вісник Нац. техн. ун-ту "ХПІ" : зб. наук. пр. Сер. : Нові рішення в сучасних технологіях = Bulletin of National Technical University "KhPI" : coll. of sci. papers. Ser. : New solutions in modern technologies. – Харків : НТУ "ХПІ", 2016. – № 42 (1214). – С. 38-42.https://repository.kpi.kharkov.ua/handle/KhPI-Press/26749З метою дослідження можливості утворення якісно нового роз’ємного з’єднання для деталей з армованих композиційних матеріалів, була розроблена, на основі раніше відомого методу технологія виготовлення подібного роз’ємного з’єднання [4]. З урахуванням всіх рекомендацій для даного типу матеріалів [1] створена геометрія інструменту, та визначеніумови оброки підібране обладнання та приладдя дляреалізаціїприведеної технології обробки.With a research objective of a possibility of creation of qualitatively new detachable joint for details from the reinforced composite materials, the manufacturing techniques of a similar detachable joint were developed on the basis of earlier known method [4]. Taking into account all recommendations for this type of materials [1] the tool geometry is created, and processing conditions are defined the equipment and accessories to realization of the given technology of processing is picked up. The recommended geometrical parameters of the cutting tool for processing of the reinforced composite materials the following: front corner у =20-30 °, rear corner a=10-15 °, point corner P = 50-60 °. The mode is realized on multiple-purpose the equipment, without use of the additional equipment and devices. Taking into account all recommendations it was also succeeded to develop new technology for a detachable joint in the reinforced composite materials. The purpose of work was development of manufacturing techniques of the offered detachable joint for the details made of the reinforced composite materials. Methods of the decision is an adaptation of earlier known mode to our conditions of processing, it very well turned out. As a result of the done work everything very well managed to be reached all objectives.ukвуглепластик􀀪􀀝􀀫􀀭􀀳􀀣􀀭􀀟􀀠􀀩􀀦 􀀱􀀑 􀀩􀀟􀀑 􀀠􀀱􀀭􀀬􀀣􀀭􀀟􀀠􀀩􀀦􀀱􀀼􀀑склопластиккругла різьбафрезеруваннятехнологія виготовленняreinforced composite materialsplug contactmanufacturing technologymillingТехнологія обробки гвинтової поверхні роз'ємного з'єднання в деталях з армованих композиційних матеріалівTechnology of processing of a crew surface of a detachable joint in details from the rainforced composite materialsArticle