Макаров, Павло Миколайович2023-08-292023-08-292023Макаров П. М. Математичне моделювання виправлення форми ротора гідроагрегату в тривимірній постановці / П. М. Макаров // Вісник Національного технічного університету "ХПІ". Сер. : Енергетичні та теплотехнічні процеси й устаткування = Bulletin of the National Technical University "KhPI". Ser. : Power and Heat Engineering Processes and Equipment : зб. наук. пр. – Харків : НТУ "ХПІ", 2023. – № 1-2 (13-14). – С. 23-27.https://repository.kpi.kharkov.ua/handle/KhPI-Press/68511Представлена робота присвячена переклинуванню обода ротора гідроагрегату для відновлення його геометрії. Для оцінки технічного стану ротора попередньо виконуються вимірювання його форми. Форма ротора розкладається в ряд Фур'є, визначається розташування його геометричної осі та еліптичність. Потім вимірюються вібрації для оцінки можливості подальшої експлуатації. І на останньому етапі виконується механічний розрахунок в тривимірній постановці для врахування розширень, що компенсують механічні деформації.The presented work is devoted to the wedging of the rotor rim of the hydraulic unit to restore its geometry. To assess the technical condition of the rotor, measurements of its shape are performed beforehand. The shape of the rotor is decomposed into a Fourier series, and the location of its geometric axis and ellipticity are determined. Based on this, a decision is made about the need for work on the centering of the hydraulic unit. Then, the vibrations of the critical components of the hydraulic unit are measured at idle without excitation and with excitation, under load in generator and pump modes to assess the possibility of its further operation. At this stage, the reasons for the unsatisfactory vibration condition of the hydraulic unit are determined. At the last stage, the boundary conditions are determined and the problem statement is performed for performing a mechanical calculation in a three-dimensional setting to take into account expansions that compensate for mechanical deformations. The calculation itself is carried out and a decision is made to wedge the rotor rim of the hydraulic unit.ukроторвібраціяграничні умовинапруженняrotorvibrationboundary conditionstensionМатематичне моделювання виправлення форми ротора гідроагрегату в тривимірній постановціMathematical modeling of the correction of the shape of the rotor of the hydraulic unit in a three-dimensional settingArticledoi.org/10.20998/2078-774X.2023.01.04https://orcid.org/0009-0008-6415-8970