Усатий, Олександр ПавловичАвдєєва, Олена ПетрівнаПальков, Ігор АндрійовичПальков, Сергій АндрійовичІщенко, Олег Ігоревич2021-11-152021-11-152021Оптимізація та порівняння двох технологій виготовлення робочих решіток для ПЧ ЦВТ турбіни К-330-23,5 / О. П. Усатий [та ін.] // Вісник Національного технічного університету "ХПІ". Сер. : Енергетичні та теплотехнічні процеси й устаткування = Bulletin of the National Technical University "KhPI". Ser. : Power and Heat Engineering Processes and Equipment : зб. наук. пр. – Харків : НТУ "ХПІ", 2021. – № 1 (5). – С. 5-14.https://repository.kpi.kharkov.ua/handle/KhPI-Press/54825В статті викладені результати багатопараметричної оптимізації конструкційних і термогазодинамічних параметрів проточної частини ЦВТ К-330-23,5, які отримані за допомогою розробленої САПР «Турбоагрегат». Знайдені 12 оптимальних рішень для проточної частини ЦВД К-330-23,5 дозволяють не тільки оцінити вплив на ефективність ЦВТ конструкційних параметрів і чисел робочих лопаток ступенів ЦВТ, а і провести порівняльний аналіз двох технологічних підходів виготовлення робочих лопаток – з підрізуванням вихідних кромок і без такої.The article presents the results of multiparameter optimization of the structural and thermogasdynamic parameters of the flow path of the HPC K-330-23.5, obtained using the developed CAD “Turboagregat”. The found 12 optimal solutions for the flow path of the HPC K-330-23.5 make it possible not only to assess the effect of the design parameters and the number of blades of the HPC stages on the HPC efficiency, but also to carry out a comparative analysis of two technological approaches to manufacturing the rotor blades – with and without trimming the initial edges. Calculations have confirmed the negative effect of increasing the radius of the “tummy” circle on the nature of the flow and on the efficiency of the cascades. In cascades with increased profiles by 9.83 % with a radius of the “tummy” circle, the coefficient of profile losses of the cascade increased by 0.07 % (absolute) in comparison with the original cascade from the original 1MMK-U profiles.ukпарова турбінаефективністьоптимізаціяпроточна частинаsteam turbineefficiencyoptimizationflow pathОптимізація та порівняння двох технологій виготовлення робочих решіток для ПЧ ЦВТ турбіни К-330-23,5Optimization and comparison of two technologies for the manufacture of blades for flow path HPC turbine K-330-23.5Articledoi.org/10.20998/2078-774X.2021.01.01https://orcid.org/0000-0002-8568-5007https://orcid.org/0000-0002-9358-4265https://orcid.org/0000-0002-4639-6595https://orcid.org/0000-0002-2215-0689