Исследование локального деформирования трубы при профилировании винтовых канавок

Loading...
Thumbnail Image

Date

item.page.orcid

item.page.doi

item.page.thesis.degree.name

item.page.thesis.degree.level

item.page.thesis.degree.discipline

item.page.thesis.degree.department

item.page.thesis.degree.grantor

item.page.thesis.degree.advisor

item.page.thesis.degree.committeeMember

Journal Title

Journal ISSN

Volume Title

Publisher

НТУ "ХПИ"

Abstract

Проведено моделирование нескольких вариантов обкатки роликом канавки на трубе с использованием программного пакета Deform 3D. В качестве профилирующих инструментов для получения винтовых канавок на тонкостенной трубе применяются ролики и оправка. Исследовано влияние диаметра ролика на напряженно-деформированное состояние и локализацию деформации.
The simulation of several variants of the roller profiling groove on the pipe using a software package Deform 3D. As a profiling tool for helical groove in a thin-walled tube are used rollers and the mandrel. The influence of the diameter of the roller on the stress-strain state and the localization of deformation was investigated.

Description

Citation

Маковей В. А. Исследование локального деформирования трубы при профилировании винтовых канавок / В. А. Маковей, П. Ю. Проценко // Вестник Нац. техн. ун-та "ХПИ" : сб. науч. тр. Темат. вып. : Новые решения в современных технологиях. – Харьков : НТУ "ХПИ". – 2011. – № 46. – С. 107-115.

Endorsement

Review

Supplemented By

Referenced By