Перегляд за Автор "Mohammed, Bassam Al-Sultan"
Зараз показуємо 1 - 2 з 2
Результатів на сторінці
Налаштування сортування
Документ Analysis of Dynamical Heat Conductivity of the Reservoir and Fluid Evacuation Zone on the Gas Condensate Well Flow Rate(2020) Anzian, Kouadio Fabrice; Fyk, M. I.; Mohammed, Bassam Al-Sultan; Abbood, Mohammed Khaleel; Abdullatif, Haval Mohammed; Shapchenko, Ye. A.This study shows that the thermal conductivity of the rock borehole adjacent to the wells varies depending on the operation of the well. This is due to the fact that the actual temperature and temperature difference affect the humidity and other thermal properties of the rocks, which in turn affect the heat transfer coeffcient across the section between the moving gas and the rocks. The static temperature field of primitive geothermal gradients acquires changes in a dynamic form. Theoretical consideration of changes in the thermal conductivity of rocks near the face and the wells is proposed to improve the prediction of gas condensate wells production. The result is achieved by introducing the specified equations of the thermal energy balance in the radial filtration and lifting of well products, which contain the coeffcients of heat exchange and throttling. The refinement bias estimation of the 10%–15% level of gas condensate well extraction is shown using proposed methodological approach to relatively well-known (traditional in the field development practice) methods for estimating the extraction of a “medium well” from a particular oil and gas field evaluation. The results of this work demonstrate important scientific, applied, educational and methodological significance of using the methodology presented by the authors.Документ Improvement of an engineering procedure for calculating the nonisothermal transportation of a gasliquid mixture(Технологический центр, 2019) Fyk, M. I.; Biletskyi, V. S.; Fyk, I.; Bondarenko, Volodymyr; Mohammed, Bassam Al-SultanThe study that we conducted into the process of transportation of a gas-condensate mixture from a well bottom to the separation production plant has revealed the features of isothermal and non-isothermal flow. It was proved that during non-isothermal flow, hydraulic losses in the product pipeline are significantly affected by throttle effect and energy accommodation effect. The influence of velocity and volumetric flow rate of the gas-liquid mixtures on hydraulic resistance and pressure drop on a section of product pipeline, taking into consideration non-isothermal flow was analyzed. It was found that the assessment of hydraulic resistance and pressure drop in the proposed dependences converges with standardized ones by 95 %. The result was obtained based on the developed system of equations of the mathematical model for non-isothermal non-stationary one-dimensional motion of the gas-liquid mixture of hydrocarbons in the pipeline. The proposed system beneficially differs from the known ones by the fact that it takes into consideration the inner convective heat exchange, estimated by the combined effect of Joule-Thomson. A distinctive feature of the improved procedure for calculation was the introduction of temperature correction and accommodation coefficient in the calculation of hydraulic resistance of a pipeline as a system with distributed parameters. Due to this, it became possible to improve the procedure for the calculation of non-isothermal transportation of a homogeneous gas-condensate mixture. Based on the analysis of calculation curves by the known procedures (formulas of Thomas Colebrooke, Leibenson and VNIIgas) for isothermal and non-isothermal processes and the proposed procedure, rational areas of their applications were shown. All calculations were performed at the velocity of a gas-liquid flow within the range 0–50 m/s, pipe roughness of 0.01–0.05 mm and their diameter of 100–300 mm, the data from actual production pipelines of Novotroitsk oil-gas condensate field were used. Comparison of the theoretical and industrial experiments showed sufficient for engineering practice accuracy of calculation of pressure drop on the stretches of oil and gas lead lines and allowed recommending the developed analytical dependences for the introduction in industrial engineering.