2022 № 97 Різання та інструменти в технологічних системах
Постійне посилання колекціїhttps://repository.kpi.kharkov.ua/handle/KhPI-Press/65926
Переглянути
Документ Structure, composition and mechanical properties of multi-layer vacuum-arc nitride coatings(Національний технічний університет "Харківський політехнічний інститут", 2022) Klymenko, S.; Klymenko, S. An.; Manokhin, А.; Stolbovoy, V.; Beresnev, V.; Šiška, F.; Chlup, Z.The conditions of application of multilayer vacuum-arc nitride coatings on a substrate made from polycrystalline cubic boron nitride (PCBN) are considered using the samples of (TiAlCrY)N/ZrN, (TiZr/TiSi)N, (TiAlSiY)N/CrN compositions. A schematic diagram of a vacuum-arc installation for applying similar coatings is presented, and the technological conditions of coating formation are considered. The structure and composition of the coatings were studied during diffractometric studies, and the performance of coated tools was examined when turning hardened steel. A large amount of the droplet phase in the (TiAlCrY)N/ZrN coating was established. The lattice parameters of two nitrides with an fcc crystal lattice were determined: ZrN – 4.590 Å, TiAlCrYN – 4.203 Å. CSR (coherent scattering region) of the ZrN phase is 5.4 nm at the microstrain level ε = 4.79·10¯³. High homogeneity and low defects in the thickness of the (TiZr)N/(TiSi)N coating were established – the amount of droplet phase is insignificant. The CSR of the coating is 24.2 nm at the level of microstrain ε = 5.76·10¯³, and the predominant texture orientation is (111). A small amount of the droplet phase was found in the (TiAlCrY)N/CrN coating. Both coating layers are characterized by the formation of phases with a cubic (fcc) crystal lattice, and a strong (111) texture occurs. The crystallographic planes (111) of the phase grains are mainly oriented parallel to the coating interface. The size of the CSR is 14.6 nm. It is shown that multilayer vacuum-arc coatings lead to an increase in the tool life of PCBN cutting tools by reducing the effect of adhesive sticking of the processed material and reducing the intensity of chemical interaction in the cutting zone.