Кафедри
Постійне посилання на розділhttps://repository.kpi.kharkov.ua/handle/KhPI-Press/35393
Переглянути
11 результатів
Результати пошуку
Документ Effect of extraterrestrial solar UV radiation on structure and properties of ZnO films obtained by wet chemical methods(Vasyl Stefanyk Precarpatian National University, 2019) Klochko, N. P.; Khrypunova, I. V.; Klepikova, K. S.; Petrushenko, S. I.; Kopach, V. R.; Zhadan, D. O.; Khrypunova, A. L.; Dukarov, S. V.; Lyubov, V. M.; Kirichenko, M. V.Документ Superhydrophobic textiles with fibers coated by nanosctructured indium-doped zinc oxide layers(Kamianets-Podіlskyi National Ivan Ohiienko University, 2020) Klochko, N. P.; Khrypunova, I. V.; Klepikova, K. S.; Kopach, V. R.; Zhadan, D. O.; Petrushenko, S. I.; Dukarov, S. V.; Lyubov, V. M.; Kirichenko, M. V.Документ Wettability of the cotton and polyester tissues coated by nanostructured indium-doped zinc oxide layers(Ivan Franko National University of Lviv, 2020) Klochko, N. P.; Khrypunova, I. V.; Klepikova, K. S.; Kopach, V. R.; Zhadan, D. O.; Petrushenko, S. I.; Dukarov, S. V.; Lyubov, V. M.; Kirichenko, M. V.; Khrypunova, A. L.Документ Flexible thermoelectric module based on zinc oxide thin film grown via SILAR(2021) Klochko, N. P.; Klepikova, K. S.; Khrypunova, I. V.; Zhadan, D. O.; Petrushenko, S. I.; Kopach, V. R.; Dukarov, S. V.; Sukhov, V. M.; Kirichenko, M. V.; Khrypunova, A. L.In this work, we used the low temperature solution growth Successive Ionic Layer Adsorption and Reaction (SILAR) for a deposition of the nanostructured undoped and indium doped (ZnO and ZnO:In) thin films on flexible polyimide (PI) substrates for their use as cheap non-toxic thermoelectric materials in the flexible thermoelectric modules of planar type to power up portable and wearable electronics and miniature devices. The use of a zincate solution in the SILAR method allows to obtain ZnO:In film, which after post-growth annealing at 300 ◦C has low resistivity ρ ≈ 0.02 Ω m, and high Seebeck coefficient 147 μV/K and thermoelectric power factor at near-room temperatures. As evidence of the operability of the manufactured films as the basis of the TE device, we have designed and tested experimental lightweight thin-film thermoelectric module. This TE module is able to produce specific output power 0.8 μW/m2 at ΔT = 50 K.Документ Electronic Parameters of a New Thin Film Composition for Kesterite Solar Cell(Прикарпатський національний університет імені Василя Стефаника, 2017) Klochko, N. P.; Khrypunov, G. S.; Kopach, V. R.; Lukianova, O. V.; Lyubov, V. M.; Kirichenko, M. V.Документ Nanostructured Semiconductor Heterostructures for Ultraviolet Sensors, Solar Cells and Semitransparent Diodes Manufactured by Chemical and Electrochemical Methods(Прикарпатський національний університет імені Василя Стефаника, 2017) Klochko, N. P.; Khrypunov, G. S.; Kopach, V. R.; Klepikova, K. S.; Lukianova, O. V.; Korsun, V. E.; Lyubov, V. M.; Zaitsev, R. V.; Kirichenko, M. V.Документ Conception of Flexible Thin-Film Solar Battery for Autonomous Hybrid Thermophotoenergy Unit(Institute of Electrical and Electronics Engineers, 2016) Kirichenko, M. V.; Zaitsev, R. V.; Lobotenko, D. S.; Zaitseva, L. V.Документ Near Ultraviolet Photodetector Based on Electrodeposited in Pulse Mode Zinc Oxide Arrays(Institute of Electrical and Electronics Engineers, 2016) Klepikova, K. S.; Klochko, N. P.; Kopach, V. R.; Khrypunov, G. S.; Lubov, V. M.; Zaitsev, R. V.; Kirichenko, M. V.Документ Hybrid thermophotoenergy module with thin-film solar cells(Taras Shevchenko National University of Kyiv, 2016) Zaitsev, R. V.; Zaitseva, L. V.; Kirichenko, M. V.Документ Double-layer ITO/Al back surface reflector for single-junction silicon photoconverters(Scientific and Technological Corporation "Institute for Single Crystals", 2008) Kopach, V. R.; Kirichenko, M. V.; Shramko, S. V.; Zaitsev, R. V.It has been shown that to increase the efficiency and manufacturability of single-crystal silicon photovoltaic solar energy converters (Si-PVC) with 180-200 μm thick base crystals having a polished photoreceiving surface and double-layer back surface reflector (BSR) consisting of a transparent oxide and aluminum layers, a conductive transparent indium-tin oxide (ITO) layer of 0.25 μm interference thickness is to be used as the nonmetallic BSR layer. It provides the ITO/Al BSR reflection coefficient in the range of 85 < R < 96 % for solar radiation photoactive component incident the Si-PVC back surface at substantially zero contribution of ITO layer resistance to the device series resistance. In the case of Si-PVC with inverted pyramid type texture of crystal photoreceiving surface at which the specificity of light distribution in the crystal causes total reflection of radiation from Si/ITO interface, the ITO layer thickness should be experimentally optimized in the 1-2 μm range independently of base crystal thickness to minimize the photoactive radiation losses and ITO layer resistance.