Кафедри
Постійне посилання на розділhttps://repository.kpi.kharkov.ua/handle/KhPI-Press/35393
Переглянути
9 результатів
Результати пошуку
Документ Electronic Parameters of a New Thin Film Composition for Kesterite Solar Cell(Прикарпатський національний університет імені Василя Стефаника, 2017) Klochko, N. P.; Khrypunov, G. S.; Kopach, V. R.; Lukianova, O. V.; Lyubov, V. M.; Kirichenko, M. V.Документ Automation of Quasi-Closed Space Method Based on ARM Microcontroller(Institute of Electrical and Electronics Engineers, 2016) Zaitsev, R. V.; Kirichenko, M. V.; Prokopenko, D. S.; Zaitseva, L. V.Документ Near Ultraviolet Photodetector Based on Electrodeposited in Pulse Mode Zinc Oxide Arrays(Institute of Electrical and Electronics Engineers, 2016) Klepikova, K. S.; Klochko, N. P.; Kopach, V. R.; Khrypunov, G. S.; Lubov, V. M.; Zaitsev, R. V.; Kirichenko, M. V.Документ Hybrid thermophotoenergy module with thin-film solar cells(Taras Shevchenko National University of Kyiv, 2016) Zaitsev, R. V.; Zaitseva, L. V.; Kirichenko, M. V.Документ Investigation the parameters of multijunction single crystal silicon solar cells with vertical diode cells test samples(Institute for Radiophysics and Electronics of the National academy of sciences of Ukraine, 2014) Polezhaeva, O. V.; Zaitsev, R. V.; Kopach, V. R.; Kirichenko, M. V.Документ Attestation of solar cells by back EMF method(Institute for Radiophysics and Electronics of the National academy of sciences of Ukraine, 2014) Lobatenko, D. D.; Kirichenko, M. V.; Zaitsev, R. V.; Kopach, V. R.Документ Development and approbation the automatization complex current-voltage characteristics measurement(Institute for Radiophysics and Electronics of the National academy of sciences of Ukraine, 2014) Prokopenko, D. S.; Zaitsev, R. V.; Kirichenko, M. V.Документ Double-layer ITO/Al back surface reflector for single-junction silicon photoconverters(Scientific and Technological Corporation "Institute for Single Crystals", 2008) Kopach, V. R.; Kirichenko, M. V.; Shramko, S. V.; Zaitsev, R. V.It has been shown that to increase the efficiency and manufacturability of single-crystal silicon photovoltaic solar energy converters (Si-PVC) with 180-200 μm thick base crystals having a polished photoreceiving surface and double-layer back surface reflector (BSR) consisting of a transparent oxide and aluminum layers, a conductive transparent indium-tin oxide (ITO) layer of 0.25 μm interference thickness is to be used as the nonmetallic BSR layer. It provides the ITO/Al BSR reflection coefficient in the range of 85 < R < 96 % for solar radiation photoactive component incident the Si-PVC back surface at substantially zero contribution of ITO layer resistance to the device series resistance. In the case of Si-PVC with inverted pyramid type texture of crystal photoreceiving surface at which the specificity of light distribution in the crystal causes total reflection of radiation from Si/ITO interface, the ITO layer thickness should be experimentally optimized in the 1-2 μm range independently of base crystal thickness to minimize the photoactive radiation losses and ITO layer resistance.Документ High-voltage power take-off system for photovoltaic station(Кременчуцький національний університет ім. Михайла Остроградського, 2016) Zaitsev, R. V.; Kirichenko, M. V.; Khrypunov, G. S.; Prokopenko, D. S.