Кафедри
Постійне посилання на розділhttps://repository.kpi.kharkov.ua/handle/KhPI-Press/35393
Переглянути
2 результатів
Результати пошуку
Документ Characteristics of specialized single-phase high voltage doubler rectifier(НТУ "ХПИ", 2018) Brzhezytskyi, V. O.; Vendychanskyi, R. V.; Trotsenko, Ye. O.; Haran, Ya. O.; Desyatov, O. M.; Khominich, V. I.To obtain a high voltage direct current, voltage multipliers with a number of cascades of three or more are widely used. At the same time, for voltage levels of 100…200 kV there are several advantages of using a specialized single-phase high voltage doubler rectifier. The main difficulty is that at the moment mathematical modeling has not been worked out for describing modes that use the built-in R, C-filter, as well as a nonlinear load in the form of Zener diodes. Generalization of the results of the authors' previous publications on the development of an analytical method for calculating the modes of a typical high-voltage direct current installation based on a specialized single-phase voltage doubler rectifier. Compilation of a system of algebraic linear and nonlinear equations that describe the current and voltage modes in the elements of a typical high-voltage direct current installation with a nonlinear load. It is shown that with the use of linearization of the current-voltage characteristics of Zener diodes used in the load circuits of a typical high-voltage direct current installation, an analytical solution for the voltages and currents in its elements can be obtained. The theoretical basis of the complex solution of the system of equations for the currents, voltages and power of the elements of a typical high-voltage direct current installation with the account of nonlinear pulsations is formulated for the first time. The obtained theoretical results can be used for calculations, design, optimization of the modes for a wide range of high-voltage direct current installations of technical, technological, and measuring purposes in the range up to 100...200 kV.Документ Application of high voltage dividers for power quality indices measurement(NTU "KhPI", 2017) Anokhin, Y. L.; Brzhezytskyi, V. O.; Haran, Ya. O.; Masliuchenko, I. M.; Protsenko, O. P.; Trotsenko, Ye. O.Introduction. Determination of power quality indices in high-voltage power grids allows to find the reasons for the deterioration of the power quality. The relevant national and International Standards for power quality contain relevant norms of quality indices and requirements for their accuracy measurement. Problem. The most complicated part in the process of measuring the power quality indices at high voltage is the selection of the corresponding high-voltage scale voltage converters. Therefore, comparing the requirements of IEC 61000-4 30 to high voltage scale voltage converters is an important task. Goal. Analysis of the International Standard IEC 61000-4-30 requirements feasibility for measuring the indices of power quality in high-voltage electrical networks using different types of high-voltage scale voltage converters. Methodology. Comparison of the requirements of IEC 61000-4-30 Standard to high-voltage scale voltage converters, when measuring power quality indices, with the characteristics of high voltage electromagnetic transformers used in Ukraine, and with promising developments of high-voltage converters of other types. Results. It is shown in the study that in order to fulfill some of the requirements for class A of IEC 61000-4-30, the characteristics of electromagnetic voltage transformers should be determined in the substation conditions using mobile calibration high-voltage laboratories. To meet all the requirements for Class A IEC 61000-4-30, it is recommended to use broadband high-voltage dividers of resistive-capacitive type. Originality. In study it is shown firstly that all the requirements of the IEC 61000-4-30 Standard for high-voltage scale voltage converters can be performed on the basis of the use of broadband resistive-capacitive damped voltage dividers. Practical value. Expositions of specific types of resistive-capacitive high-voltage dividers are presented, their parameters are confirmed by the results of state metrological certification.