Кафедри
Постійне посилання на розділhttps://repository.kpi.kharkov.ua/handle/KhPI-Press/35393
Переглянути
3 результатів
Результати пошуку
Документ Analyzing the effect of the tool pass number and the direction of sliding burnishing on surface roughness(Національний технічний університет "Харківський політехнічний інститут", 2022) Nagy, Antal; Varga, GyulaNowadays, the concern of environmental protection is becoming more and more important in production as well. They often contribute to this by reducing or eliminating the amount of coolants and lubricants, or by using alternative machining methods. One of them is burnishing, which makes a positive effect on surface integrity, while reduces the environmental load. In this paper we examined the change in surface roughness achieved by burnishing after turning on a corrosion-resistant steel workpiece, where the number of burnishing passes and burnishing direction were changed. The results showed increased smoothness, bearing capacity and dimensional stability by increasing the number of passes from 1 to 2, however, the 3 times repetition did not show any additional favorable improvement on the surfaces. In case of the forward-backward-forward burnishing directions, further chipping occurred, in other cases the effect of the directions was negligible on the amplitude roughness parameters, but considerable on the parameters characterizing the roughness peak. The greatest improvement was achieved with the backward-forward settings.Документ The effect of burnishing process on skewness and kurtosis of the scale limited surface(Національний технічний університет "Харківський політехнічний інститут", 2022) Ferencsik, Viktoria; Varga, GyulaIn this paper roughness examination and analysis on burnished low alloyed aluminium surfaces are reported, highlighting 2 parameters from the vertical deviations of the roughness profile from the mean line. From the input parameters of the burnishing process, the effect of burnishing force, feed rate, speed and number of passes are investigated. Measurements of the surface topography – before and after burnishing – are conducted on an Altisurf 520 3D measuring device. The generated and calculated values of the machined surface roughness are analysed in detail with the drawing of the conclusions as well.Документ Examination of residual stresses on diamond burnished cylindrical surfaces(НТУ "ХПИ", 2017) Varga, Gyula; Ferencsik, ViktoriaCold plastic finish manufacturing methods such as surface rolling, burnishing and surface hardening with shot peening play important role in the lifetime increasing manufacturing as compressive residual stress remains in near surface layers of the workpiece. This paper deals with examination of changing of residual stress caused by burnishing using diamond tipped tools. The diamond burnishing executed on outer cylindrical surfaces is a finishing manufacturing operation which results high accuracy and fine surface texture. The aim of the examinations was to determine how the burnishing speed, feed rate and burnishing force has affect on the residual stresses in case of diamond burnishing of low alloyed aluminium shafts. The Taguchi type Factorial experiment design was used for planning of experiments. The measurement of residual stresses was performed by an X-ray diffraction method. The evaluation of measured results was done by a specially specified ratio to determine the parameter set which results the best residual stress values in between the given range of technological parameters.