Кафедри
Постійне посилання на розділhttps://repository.kpi.kharkov.ua/handle/KhPI-Press/35393
Переглянути
6 результатів
Результати пошуку
Документ Nanostructured Semiconductor Heterostructures for Ultraviolet Sensors, Solar Cells and Semitransparent Diodes Manufactured by Chemical and Electrochemical Methods(Прикарпатський національний університет імені Василя Стефаника, 2017) Klochko, N. P.; Khrypunov, G. S.; Kopach, V. R.; Klepikova, K. S.; Lukianova, O. V.; Korsun, V. E.; Lyubov, V. M.; Zaitsev, R. V.; Kirichenko, M. V.Документ Conception of Flexible Thin-Film Solar Battery for Autonomous Hybrid Thermophotoenergy Unit(Institute of Electrical and Electronics Engineers, 2016) Kirichenko, M. V.; Zaitsev, R. V.; Lobotenko, D. S.; Zaitseva, L. V.Документ Near Ultraviolet Photodetector Based on Electrodeposited in Pulse Mode Zinc Oxide Arrays(Institute of Electrical and Electronics Engineers, 2016) Klepikova, K. S.; Klochko, N. P.; Kopach, V. R.; Khrypunov, G. S.; Lubov, V. M.; Zaitsev, R. V.; Kirichenko, M. V.Документ Hybrid thermophotoenergy module with thin-film solar cells(Taras Shevchenko National University of Kyiv, 2016) Zaitsev, R. V.; Zaitseva, L. V.; Kirichenko, M. V.Документ Double-layer ITO/Al back surface reflector for single-junction silicon photoconverters(Scientific and Technological Corporation "Institute for Single Crystals", 2008) Kopach, V. R.; Kirichenko, M. V.; Shramko, S. V.; Zaitsev, R. V.It has been shown that to increase the efficiency and manufacturability of single-crystal silicon photovoltaic solar energy converters (Si-PVC) with 180-200 μm thick base crystals having a polished photoreceiving surface and double-layer back surface reflector (BSR) consisting of a transparent oxide and aluminum layers, a conductive transparent indium-tin oxide (ITO) layer of 0.25 μm interference thickness is to be used as the nonmetallic BSR layer. It provides the ITO/Al BSR reflection coefficient in the range of 85 < R < 96 % for solar radiation photoactive component incident the Si-PVC back surface at substantially zero contribution of ITO layer resistance to the device series resistance. In the case of Si-PVC with inverted pyramid type texture of crystal photoreceiving surface at which the specificity of light distribution in the crystal causes total reflection of radiation from Si/ITO interface, the ITO layer thickness should be experimentally optimized in the 1-2 μm range independently of base crystal thickness to minimize the photoactive radiation losses and ITO layer resistance.Документ New approach to the efficiency increase problem for multi-junction silicon photovoltaic converters with vertical diode cells(Scientific and Technological Corporation "Institute for Single Crystals", 2008) Kopach, V. R.; Kirichenko, M. V.; Shramko, S. V.; Zaitsev, R. V.; Bondarenko, S. A.It is shown, that for efficiency increase of multi-junction photovoltaic solar energy converters with vertical diode cells (VDC) on the basis of single-crystal silicon the modernization of VDC by the introduction along their vertical Si-boundaries single-layer indiumtin oxide reflectors by thickness more than 1 μm is necessary.