Кафедра "Фізика металів і напівпровідників"

Постійне посилання колекціїhttps://repository.kpi.kharkov.ua/handle/KhPI-Press/4703

Офіційний сайт кафедри http://web.kpi.kharkov.ua/fmp

Від 2002 року кафедра має назву "Фізика металів і напівпровідників", попередня назва – кафедра металофізики.

Кафедра металофізики організована в 1930 році у складі фізико-механічного факультету ХММІ. Деканом факультету був у ті роки видатний вчений-фізик, академік Іван Васильович Обреїмов.

Кафедра входить до складу Навчально-наукового інституту комп'ютерного моделювання, прикладної фізики та математики Національного технічного університету "Харківський політехнічний інститут". За час існування кафедрою підготовлено близько 3000 інженерів, у тому числі і для зарубіжних країн.

У складі науково-педагогічного колективу кафедри працюють: 3 доктора та 2 кандидата фізико-математичних наук; 3 співробітника мають звання професора.

Переглянути

Результати пошуку

Зараз показуємо 1 - 4 з 4
  • Ескіз
    Документ
    Growth and structure of WC/SI multilayer X-ray mirror
    (Національний науковий центр «Харківський фізико-технічний інститут», 2018) Pershyn, Yuriy P.; Chumak, V. S.; Shypkova, I. G.; Mamon, Valentine V.; Devizenko, A. Yu.; Kondratenko, Valeriy V.; Reshetnyak, M. V.; Zubarev, Evgeniy N.
    WC/Si multilayer X-ray mirrors (MXMs) with nominal layers thicknesses of 0.2…30.3 nm (periods: 0.7…38.9 nm) were deposited by direct current magnetron sputtering and studied by X-ray diffraction and crosssectional transmission electron microscopy (TEM). Carbide and silicon layers are amorphous throughout the studied thickness range. The WC layers interact with Si layers with formation of tungsten silicides (WSi2, W5Si3) and silicon carbide in as-deposited state. The bottom interlayer (WC-on-Si) consists of two subzones of approximately equal thickness. An estimation of the thickness, density, and composition of all layers is made. Based on the experimental data, a five-layer model of the WC/Si MXM structure is suggested.
  • Ескіз
    Документ
    The structure of Mo/Si multilayers prepared in the conditions of ionic assistance
    (Springer, 2008) Zubarev, Evgeniy N.; Kondratenko, V. V.; Sevryukova, V. A.; Yulin, S. A.; Feigl, T.; Kaiser, N.
    The influence of a negative substrate-applied bias potential on the structure of periodic Mo/Si multilayer compositions has been investigated by means of cross-sectional electron microscopy, small-angle X-ray reflectivity, X-ray diffraction and by modeling the small-angle spectra. It is known that the crystalline structure of molybdenum layers is the main source of interface roughness. In the absence of a bias potential application, the interface roughness tends to develop from the substrate towards the surface of a Mo/Si multilayer composition. A negative bias potential (up to −200 V) applied to a substrate during silicon layer deposition leads to smoother interfaces and improves the layer morphology. After increasing the bias potential over −200 V a considerable growth of an amorphous interlayer transition zone can be observed at Si-on-Mo interfaces. By raising the bias potential during the deposition of Mo layers a development of roughness at Mo-on-Si interfaces as well as growing interlayer thicknesses were found.
  • Ескіз
    Документ
    Kinetics of phase transitions in highly oriented graphite intercalated with potassium
    (STC "Institute for Single Crystals", 2020) Mikhailov, I. F.; Zubarev, Evgeniy N.; Mikhailov, A. I.; Mamon, V. V.; Borisova, S. S.; Surovitskiy, S. V.
  • Ескіз
    Документ
    Behavior of the Ti-Zr-Ni thin film containing quasicrystalline and approximant phases under radiative-thermal action in transition modes
    (Kharkiv Institute of Physics and Technology, 2020) Malykhin, S. V.; Makhlai, V. A.; Surovitskiy, S. V.; Garkusha, I. E.; Herashchenko, S. S.; Kondratenko, V. V.; Kopylets, I. A.; Zubarev, Evgeniy N.; Borisova, S. S.; Fedchenko, A. V.
    X-ray diffraction and SEM microscopy were used to study the structural and phase changes in a thin film obtained by magnetron sputtering of a Ti52Zr30Ni18 target (at.%) on a steel substrate under the radiation-thermal influence of pulsed hydrogen plasma on an QSPA Kh-50 accelerator. A technique has been worked out for the formation of the quasicrystalline and crystal-approximant phases as a result of high-speed quenching using pulsed action with a heat load of 0.6 MJ/m². The changes in the contents of these phases as well as in their structure and substructure parameters were studied during isothermal vacuum annealing at a temperature of 550 °C and also as a result of irradiation with 5 plasma pulses in the range of heat load from 0.1 to 0.4 MJ/m². The quasicrystalline phase was found to be resistant to irradiation with hydrogen plasma.