Кафедра "Безпека праці та навколишнього середовища"

Постійне посилання колекціїhttps://repository.kpi.kharkov.ua/handle/KhPI-Press/2354

Офіційний сайт кафедри http://web.kpi.kharkov.ua/safetyofliving

Від 2020 року кафедра має назву "Безпека праці та навколишнього середовища", попередня назва – "Охорона праці та навколишнього середовища", первісна назва – кафедра "Охорона праці".

Кафедра "Охорона праці" була створена в 1963 році. Першим її завідувачем був доцент Наумов С. С., який очолював кафедру протягом 1963-1970 років.

За час існування кафедри, крізь її "стіни" пройшло понад 70 тисяч студентів.

Кафедра входить до складу Навчально-наукового інституту механічної інженерії і транспорту Національного технічного університету "Харківський політехнічний інститут".

У складі науково-педагогічного колективу кафедри працюють 25 викладачів, серед яких 2 доктора технічних наук, 17 – кандидатів технічних, біологічних та психологічних наук, 1 – доктор філософії, 3 співробітника мають звання професора, 14 – доцента.

Переглянути

Фільтри

2017 - 20194

Налаштування

Автор: search.filters.author.Raiko, ValentinaORCID: search.filters.orcid.https://orcid.org/0000-0001-6268-8638

Результати пошуку

Зараз показуємо 1 - 4 з 4
  • Ескіз
    Документ
    Studying patterns in the flocculation of sludges from wet gas treatment in metallurgical production
    (PC Technology center, 2019) Shestopalov, Oleksii; Briankin, Oleksandr; Tseitlin, Musii; Raiko, Valentina; Hetta, Oksana S.
    The influence of a solid phase concentration in the model sludges of wet gas purification, as well as the flocculant consumption, on a change in the solid phase sedimentation rate and the strength of floccules has been examined. This is important because fluctuations in the solid phase concentration in waste water represent an uncontrolled process that significantly affects the kinetics of the solid phase sedimentation and leads to an increase in the flocculant consumption. We have proposed a procedure for determining the sedimentation rate of the flocculated sludge and the strength of floccules following the hydromechanical influence, which takes into consideration the solid phase concentration and the flocculant consumption. The study was carried out on model waste water, synthesized by mixing the dust from dry gas purification at actual production site with water. It has been determined that the solid phase concentration affects the rate of floccule deposition. It has been established that the optimum conditions for aggregate formation within a given model system are observed at the solid phase concentration in the interval 8–12 g/l. Increasing the solid phase concentration above 16 g/l decreases the floccule sedimentation rate disproportionately to the flocculant concentration. It is possible to reduce flocculant consumption and to optimize its dosage by carrying out a cleaning process taking into consideration the specified patterns. It was established that the hydromechanical influence on aggregates exerts the destructive effect, whose degree depends on the solid phase concentration. In particular, increasing the rate of fluid motion leads to greater damage to floccules than increasing the time for a less intense exposure. The way to minimize the destructive effect on floccules could be lowering the suspension transportation speed resulting from a decrease in the installation performance or through the increased cross-section of the channel (a pipeline). An increase in the solid phase concentration of the model system above 16 g/l is accompanied by a significant reduction in the strength of floccules. Therefore, when designing wastewater treatment plants that utilize flocculants, it is necessary to provide optimum conditions for aggregation and to minimize the hydromechanical effects on floccules by lowering the velocity of fluid motion.
  • Ескіз
    Документ
    Analysis of ways reducing drilling waste in oil and gas production influencing on natural environment
    (UNIVERSITAS Publishing, Romania, 2019) Shestopalov, Oleksii; Rykusova, N. I.; Tseitlin, Musii; Raiko, Valentina
  • Ескіз
    Документ
    A study of the flocculs strength of polydisperse coal suspensions to mechanical influences
    (Scientific Route, 2017) Shkop, Andrii; Tseitlin, Musii; Shestopalov, Oleksii; Raiko, Valentina
    The effect of the concentration and disperse composition on the flocculation strength to mechanical influence is investigated. It is found that the residual rate of floccules sedimentation after the mechanical influence at a constant rate of flocculant has a maximum value at a concentration of solids in the slime in the range of 7–30 g/dm3. The best results are obtained in all the experiments at a solids concentration of 10 g/l. It is found that at a concentration up to 7 g/l and more than 30 g/l, the floccules is formed. They have the lowest residual rate after mechanical influences. With increasing content of the solid fraction of 40–100 microns over 15 %, the strength of floccules increases. They retain their shape and relatively high sedimentation rate even after mechanical influence. The obtained data allow to recommend correction of the slime composition before flocculant injection both the concentration close to the optimum, and the content of size fraction of 40–100 mm more than 15 %.
  • Ескіз
    Документ
    Study of the strength of flocculated structures of polydispersed coal suspensions
    (Технологічний центр, 2017) Shkop, Andrii; Tseitlin, Musii; Shestopalov, Oleksii; Raiko, Valentina
    The influence of concentration, dispersed composition and degree of thickening of the flocculated slime on the strength of floccules was studied. It was revealed that for the formation of durable aggregates of polydispersed coal slime it is recommended to apply the combination of the non-ionogenic and anionogenic flocculant in the ratio of 20:80 % respectively. It was established that the residual sedimentation rate of floccules after mechanical influence at the constant consumption of the flocculant has the greatest value at the concentration of solid phase in slime of 10–30 g/dm3. With an increase in the content of the portion of solid phase with coarseness of more than 40 µm, the strength of floccules increases to the larger degree than the influence of the initial concentration. This makes it possible to recommend the correction of the slime composition not only by the concentration, but also by the content of medium grade of more than 15–20 %. It was shown that with an increase in the degree of thickening of more than 140–150 g/l the resistance of aggregates to mechanical influence substantially decreases due to an increase in pseudo-plastic properties of flocculated slime.