Повышение точности построения изделий на установках селективного лазерного спекания
Loading...
Date
item.page.orcid
DOI
item.page.thesis.degree.name
item.page.thesis.degree.level
item.page.thesis.degree.discipline
item.page.thesis.degree.department
item.page.thesis.degree.grantor
item.page.thesis.degree.advisor
item.page.thesis.degree.committeeMember
Journal Title
Journal ISSN
Volume Title
Publisher
НТУ "ХПИ"
Abstract
The features of technology of selective laser sintering are considered. Causes of residual deformations products are analyzed. The necessity of application of compensating deformation of initial triangulation model is reasonable. The experimental check was shown, that the compensative deformation of triangulation model allows increasing accuracy when building products at selective laser sintering installation.
Description
Citation
Доброскок В. Л. Повышение точности построения изделий на установках селективного лазерного спекания / В. Л. Доброскок, Ю. Б. Витязев, А. В. Погарский // Резание и инструмент в технологических системах = Cutting & tool in technological system : междунар. науч.-техн. сб. – Харьков : НТУ "ХПИ", 2014. – Вып. 84. – С. 77-84.