Вісник № 57
Постійне посилання зібрання
Переглянути
Нові надходження
Документ Збагачення молочних продуктів риб'ячим жиром(НТУ "ХПІ", 2013) Юр'єва, Марина СергіївнаIn the article the analysis of an up-to-date status of dairy products fortification with fish oil was performed. The structure and characteristics of eicosapentaenoic and docosahexaenoic fatty acids, as well as their influence on human health were researched. Also a new research considering soft goat cheese fortification with fish oil to deliver healthy omega-3 fatty acids was analyzed. Production of a dairy product containing structured fish oil was suggested.Документ Применение топологического моделирования в физико-химической динамике и в технологии дисперсных систем и материалов(НТУ "ХПИ", 2013) Трофимова, Л. Е.; Урьев, Н. Б.It is suggested for description of aberrant behavior of some disperse systems and materials to attract the topology approach based on the theory of catastrophes. The processes of disperse systems formation are analysed in dynamic conditions. Specific examples were used to demonstrate the expediency of the use of this methodical approach in a complex with the accepted instrumental methods of research of properties of the structured disperse systems and materials on their basis.Документ Дослідження процесу ущільнення гідроксиапатитної кераміки при мікрохвильовому спіканні(НТУ "ХПІ", 2013) Товстоног, Г. Б.; Сич, О. Є.; Скороход, В. В.In this work the characteristics of microwave sintering of porous hydroxyapatite ceramics have been investigated. It was established that use of microwave sintering at 1000 °C provides to obtain ceramics based on biogenic hydroxyapatite with porosity of 35 – 46,5 % that was 90 – 95 % open, and compressive strength 21 – 67 MPa. It was shown that increase of compacting pressure from 50 upto 250 MPa promotes the formation of a fine-grained ceramics with particle size 0,06 – 1,37 μm and reduction existence interval of the most pores down to 0,2 – 0,7 μm.Документ Получение мелкодисперсных композитов в системе Салм. − Ti − Si(НТУ "ХПИ", 2013) Стратийчук, Д. А.; Туркевич, В. З.; Колабылина, Т. В.; Осипов, А. С.; Смирнова, Т. И.This work is devoted to the study of phase interaction in the ternary Cdiamond – Ti – Si system and was conducted to determine the optimum conditions for the formation of high-strength diamondcontaining composites. By using high static pressure (7.7 GPa), it was shown that starting from 1500 °C the binder component Ti3SiC2 decomposes to form the fine dispersed TiC and high-pressure b-SiC phases. Obtained diamond based composite is characterized by high physic and mechanical characteristics and can be used for stone processing.Документ Хімічна взаємодія й фазоутворення у сульфатних, нітратних, хлоридних водно-сольових системах неодиму і лужних металів(Національний технічний університет "Харківський політехнічний інститут", 2013) Стороженко, Дмитро Олексійович; Дрючко, Олександр Григорович; Бунякіна, Наталія Володимирівна; Іваницька, Ірина ОлександрівнаUsing the complex of physical-chemical methods authors studied the nature and regularities of chemical interaction of the structural components and heterogeneous equilibrium (25 – 100 °С) in ternary water-salt systems of neodymium and IA group elements sulfates, nitrates and chlorides. A number of peculiarities and regularities of their combined interaction have been found.Документ Інноваційна технологія дроблення магнетитових кварцитів в полі відцентрових сил та її вплив на ефективність рудопідготовки(НТУ "ХПІ", 2013) Сокур, Микола Іванович; Сокур, Л. М.; Сокур, І. М.A study of the processes of fragmentation in magnetite quartzite cone crusher and centrifugal-type shock. It is shown that crushing ore in the crusher centrifugal type can significantly improve the performance rudopidhotovky, in particular to reduce energy consumption by 12 – 15 %, improve grinding efficiency and quality of concentrate by 1.5 – 2 %. A new innovative technology rudopidhotovky using centrifugal type crushers.Документ Моделирование свойств самоуплотняющегося бетона при поэтапном введении добавок(НТУ "ХПИ", 2013) Салих, Ф.; Коваль, С.The method of maintenance of technological properties of self-compacting concrete mixture offers and investigational in the conditions of dry roast of climate at stage-by-stage introduction of additions.Документ Композиционный кладочный материал(НТУ "ХПИ", 2013) Руссу, И. В.The results of research on the optimization of the structure and properties of composite material from local raw materials for construction of walls. Experimentally proved that disperse reinforcement of composite material with biomass together with improved mechanical strength greatly reduces its thermal.Документ Процессы, происходящие при структурировании гибридных полимеркерамических композитов на основе фосфатов кальция(НТУ "ХПИ", 2013) Рассоха, Алексей Николаевич; Кривилева, Светлана ПавловнаIn the article all areas of the use and mechanisms of structurization of composition materials for medical-technical use and its defects were analyzed. A perspective hybrid polymer-ceramic material on the basis of calcium phosphate was elaborated, the mechanism its structurization was learned.Документ Вплив величини вакууму при охолодженні на структуру та властивості сплаву ВК10ОМ після компресійного спікання під тиском газу(НТУ "ХПІ", 2013) Прокопів, М. М.; Харченко, О. В.Presented results of researches of influence of size of vacuum at cooling on a structure and properties of alloy of VK10OM after compression spikannya. Is it rotined that optimum structure and maximal fiziko-mechanical properties of alloy of VK10OM after compression spikannya force-feed Р – 2,5 MPa, turn out at cooling with the vacuum of Р – 1×10‾⁴ MPa.Документ Влияние длительности помола электрокорунда на свойства низкоцементного бетона(НТУ "ХПИ", 2013) Песчанская, В. В.; Макарова, А. С.Experimental studies have been conducted unveiling influence of time of grinding on change of its reaction of activity, the process of hardening the matrix component, and the flowing properties of the concrete mass and properties low-cement refractory corundum concretes.Документ Использование элементов фрактальной геометрии для расчета дисперсных характеристик измельченного материала(НТУ "ХПИ", 2013) Орлова, Н. Д.This article contains the formula for calculating the surface area of crushed material using the concepts of fractal geometry. The process of destruction examined from the perspective of the evolution of the interfaces of the individual structural elements and the subsequent development of cracks on these surfaces. Nucleation and propagation of cracks is described from the perspective of fractal geometry as the formation of a fractional-dimensional layer.Документ Модернизация вибрационного валкового классификатора на основе использования виброударного режима(НТУ "ХПИ", 2013) Надутый, В. П.; Егурнов, А. И.; Ягнюкова, И. В.The modernized chart of executive device of roller vibroclassifier is offered. The conditions of its vibroimpact mode are determined and basic calculation dependencies are represented.Документ Совершенствование рудоподготовки при обогащении нефелиновых сиенитов для повышения извлечения пирохлора(НТУ "ХПИ", 2013) Мостыка, Ю. С.; Шпилевой, К. Л.; Шпилевой, Л. В.These researches have been done with the purpose of ore-dressing technology perfection for nefelin-siyenit ores of the Mazurovsky deposit on the basis of selective crushing of minerals before their gravitational separation in centrifugal field.Документ Клинкерные керамические изделия для облицовки зданий и дорожных покрытий на основе глинистого сырья Пологовского региона(НТУ "ХПИ", 2013) Миршавка, О. А.; Хоменко, Е. С.; Коледа, В. В.; Скакун, В. Ю.The article shows the possibility of expanding the assortment of ceramic products in the enterprise "Chapaevsky brickyard" (Zaporozhye.). When using the structuring and modifying additives based on local raw materials is possible to obtain ceramics with properties approaching those of clinker materials: compressive strength of 50 – 70 MPa, water absorption of 5 – 3 %. In addition, the products are of auniform dark rich red-brown color and high aesthetic values.Документ Влияние способа подготовки шихты на фазовый портрет синтеза бериллиевого индиалита в субсолидусной области(НТУ "ХПИ", 2013) Мамонтова, С. Г.; Михайлов, М. А.; Богданова, Л. А.It is established that the ceramic and sol-gel technique to obtain beryllian indialite by solid-state method differ both on the phase, and local levels of the crystallogenic medium organization. It emphasized the originality of conduct totals complexity associations phases arising under each of the techniques.Документ Определение характеристик точности технологических процессов(НТУ "ХПИ", 2013) Лысенко, А. А.Depending on the accuracy of the process and the required precision control of the original ore and concentrate control accuracy is determined by a given point in the production line enrichment.Документ Анализ перераспределения фаз в диффузионных силицидных покрытиях при их эксплуатации в воздушной среде(НТУ "ХПИ", 2013) Литовченко, С. В.; Чишкала, В. А.This paper is an attempt to compare the theoretical calculations and experimental data to the study on the phase changes in the silicide coatings on molybdenum and tungsten. To prevent unacceptable changes, it is necessary to foresee the evolution of structure during formation of the coating and during operation of the composite. This paper analyzes the phase change that determine degradation of properties of the coatings.Документ Поверхностная активность и прочностные (вяжущие) свойства активированных доменных шлаков(НТУ "ХПИ", 2013) Кравченко, В. П.; Ганкевич, В. Ф.Based on analysis of the processes under the influence of an external crystal at breaking load valence unsaturation (reactive, for example, ion oxide radicals O–) concluded identity by dispersing increasing of the surface activity and strength (binding) properties blast-furnace slag.Документ Внедрение полимерных связующих в производство металлургических брикетов(НТУ "ХПИ", 2013) Кийк, А. А.; Маркова, С. В.; Кормина, И. В.The problems of usingbinders forbriquetting and sinteringin the steelindustry are considered.The results ofindustrial testsof modern domesticpolymericbindersare given.